Your course

Pick up where you left off.

Current Status

Not Enrolled

Price

$99.00

Get Started

Course Content

I. Introduction (2 minutes)
II. Learning Objectives (1 minute)
III. Module 1: Two Systems, One Map (11 minutes)
IV. Module 2: Landslip (11 minutes)
V. Module 3: Riverine and Coastal Inundation (11 minutes)
VII. Case Studies (5 minutes)
VIII. Summary and Key Takeaways (2 minutes)
For building designers documenting houses on Tasmanian hazard land

Building on Hazard Land in Tasmania

Read the band, not just the overlay. Set the floor from the level, not the rule of thumb.

Landslip, riverine flood, coastal inundation and coastal erosion, under the Tasmanian Planning Scheme and the Director’s Determinations, as at November 2026. Work out which system controls the site, apply the band requirements, find the defined flood level, and brief and document the reports your building surveyor will ask for.

60 minutes, self-paced Intermediate level 1 formal CPD point Certificate on completion Tasmania, November 2026
Aligned to NSCA 2021 PC16 PC32 PC39 PC41 PC46
$99 inc. GST, one-off
  • Product neutral, no supplier content
  • Audio version and glossary included
  • Certificate saved to your dashboard

Secure card checkout. Tax invoice emailed.

Course content

4 modules, 2 case studies, final quiz and certificate.

Start 3 min

Introduction and objectives

The three mistakes that cause most delay on hazard land, and the four objectives.

Module 1 11 min

Two Systems, One Map

What makes land a hazardous area, the four planning hazard codes, when the planning code steps aside, the Director’s Determinations and which code applies today.

Module 2 11 min

Landslip

Reading the landslip bands, low and medium bands, medium-active, high and declared areas, significant work in the earthworks, and the landslip hazard report.

Module 3 11 min

Riverine and Coastal Inundation

Riverine flooding in planning, finding the defined flood level, coastal inundation bands and the 2100 level, and the ABCB flood standard on a Tasmanian house.

Module 4 11 min

Coastal Erosion and the Hazard Documentation Set

Erosion bands and mobile landforms, who prepares which report, briefing the consultant, what goes on your drawings and the approval sequence.

Case studies 5 min

The Hobart garage cut and the Huonville floor

A garage cut on a medium band Hobart hillside, and a Huonville floor set to the wrong rule.

Summary 2 min

Key takeaways

The checks to carry onto your next hazard land job.

Finish

Final quiz and certificate

Ten scenario questions. Pass and the certificate goes straight into your dashboard.

Intermediate. For practitioners who already document Class 1 and Class 10 work in Tasmania. Reflects the Tasmanian Planning Scheme, the Building Act 2016, the Building Regulations 2016, the Director’s Determinations and NCC 2022 Amendment 2 as published in November 2026. Confirm the overlays, bands, levels and reports for each project with your council, your building surveyor and the relevant practitioners. General professional education, not legal, engineering or planning advice.

Who it is for

Written for the people who design, check, build and assess on Tasmanian hazard land.

Building Designer

You set the footings, floor levels and earthworks that the hazard bands decide.

1 formal CPD point

Architect

Your Tasmanian sites carry overlays that shape the design before the first sketch.

1 formal CPD point

Building Surveyor

You ask for the reports and check the levels and conditions on the drawings.

1 CPD point

Licensed Builder

You build the cuts, fills, drainage and floors the reports allow.

1 CPD point

Civil Engineer

You prepare the hazard reports and need a brief that asks the right questions.

1 CPD point
How it counts

Where this hour goes on your record.

National Standard of Competency for Architects (NSCA 2021) performance criteria this course aligns with:

PC16

Risk management and climate resilience

PC32

Planning principles and statutory planning

PC39

Integrating materials and construction systems

PC41

Coordinating specialists and consultants

PC46

Compliant project documentation

If you are

How it is recorded

A building designer

1 formal CPD point. Your certificate, the learning outcomes, the module outline and your quiz result are kept in your dashboard, so you can show what you studied if your CPD is audited.

An architect

1 formal CPD point. Aligned with NSCA 2021 performance criteria PC16, PC32, PC39, PC41 and PC46.

A building surveyor, licensed builder or civil engineer

1 hour of CPD on building on Tasmanian hazard land, recorded on your certificate for your registration or licensing body.

CPD On Demand is not a registered training organisation and courses are not accredited by any registration body. Each course is aligned with the relevant competency frameworks and gives you the records to evidence it. CPD rules differ by registration body and state, so check with yours if you are unsure.

  • Examine how the planning hazard codes and Part 5 divide hazard land between the two systems.
  • Apply the landslip band requirements to site classification, footings and earthworks.
  • Recognise significant work and when a landslip hazard report is needed.
  • Evaluate a floor level and construction approach on riverine or coastal inundation land.
  • Justify the reports and practitioners a hazard site needs.
  • Document the hazard reports, levels and conditions on your drawings.
Keep going

Pairs well with.

Building designers

Livable Housing Design (NCC Part H8): Getting It Right on Tasmanian Homes

Another Tasmanian house provision, clause by clause.

Building designers

Fire Separation and Fire-Resisting Construction for Townhouses and Units

Separating walls, boundaries and small unit buildings, with the Tasmanian position.

Building designers

How the NCC Actually Works: Structure, Responsibility & Compliance Pathways

Performance requirements, deemed-to-satisfy solutions and who decides.

Questions

Before you enrol.

No. The planning hazard codes, Part 5 of the Building Regulations and the Director’s Determinations are Tasmanian. The ABCB flood standard it uses is national, but the levels and bands come from Tasmanian instruments.

Start, stop and finish later. Progress is saved and the course stays in your dashboard.

Yes, on passing the final quiz. It is stored in your dashboard alongside your other CPD records.

No. It shows when a report is needed, who prepares it, how to brief them and what goes on your drawings; the report itself is the consultant’s work.

Yes. Team packs start at $579 for six courses shared across your practice.

No. Every course is product neutral. No footing, drainage or flood product is named, and there is no sales pitch at the end.

Get your next Tasmanian hazard land job through approval first time, in one self-paced hour.

$99, 60 minutes, certificate on completion.

$99 1 hour, certificate